Chauvet Professional MAVERICKMK2WASH Mode D'emploi page 47

Operation
Loss of data
In case of an input signal being lost in any way, the Maverick MK2 Wash will respond in one of two ways.
the product will either hold the last signal received, or black out all LED output.
To set which way the product responds, follow the instructions below:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Loss of Data, or touch the display where it says Loss of Data.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Hold (hold last signal received) or Close
(black out all LED output), or touch the display where it says the desired option.
5. Press <ENTER>.
Fan speed
To set the speed of the fans, do the following:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Fans, or touch the display where it says Fans.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Auto (fan speed set according to product
temperature), Full (maximum speed), or ECO (quiet fans mode), or touch the display where it says
the desired option.
5. Press <ENTER>.
Color mixing mode
The Maverick MK2 Wash has a mode that emulates CMY (cyan, magenta, and yellow) color mixing. In this
mode, the dimming is reversed (000=100%, 255=0%), and the red, green, and blue channels control cyan,
magenta, and yellow, respectively.
To set the color mixing mode:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select C Mixing Mode, or touch the display where it says C Mixing Mode.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select RGBW (additive mode: red, green, blue,
and white), or CMY (subtractive mode: red controls cyan, green controls magenta, blue controls
yellow), or touch the display where it says the desired option.
5. Press <ENTER>.
Dimmer curve
To set the dimmer curve, follow the instructions below:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Dimmer Curve, or touch the display where it says Dimmer
Curve.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Linear, Square, I Squa, or SCurve, or
touch the display where it says the desired option.
5. Press <ENTER>.
Dimmer speed
To set the dimmer speed, do the following:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select Dimmer Speed, or touch the display where it says Dimmer
Speed.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select Smooth or Fast, or touch the display where
it says the desired option.
5. Press <ENTER>.
Pulse Width Modulation
To adjust the frequency of the pulse width modulation:
1. Navigate to the Setup
2. Use <UP> or <DOWN> to select PWM Options, or touch the display where it says PWM Options.
3. If using the buttons instead of the touchscreen, press <ENTER>.
4. Use <UP>, <DOWN>, <LEFT>, or <RIGHT> to select 600Hz, 1200Hz, 2000Hz, 4000Hz, 6000Hz,
or 15000Hz, or touch the display where it says the desired option.
5. Press <ENTER>.
Maverick MK2 Wash User Manual Rev. 15
menu.
menu.
menu.
menu.
menu.
main level.
Page 32 of 197