NESTOR MARTIN NIQ43 Instructions D'installation, De Service Et D'entretien page 46

2.1. FRAME (993900414)
2.2. REMOTE CONTROL (993900039)
A remote control is available as an option. The remote control can be used to adjust the fire rate remotely,
or thermostatically.
To install the motor and receiver, proceed as follows:
Remove the control panel (2 screws)
1.
Connect the electrical lead to the receiver
3.
box and place the receiver above the box.
2.
fastener
Fig. 23
Fig. 25
OPTIONAL EXTRAS
Fig. 22
Pull back the strap of the magnet then wedge
2.
the muff of the motor against the magnet.
Strap
Motor
For full instructions on using the remote control,
please refer to the Remote Control User Guide
supplied with the remote control kit.
46
To fix the frame, slide the 4
fasteners into the 4 supports
provided for this purpose.
Magnet
Fig. 24a
Fig. 24b