Clarke Focus II Disc 34 Manuel D'utilisation page 18

ENGLISH
EN
HOW TO OPERATE THE MACHINE
How To Operate The Chemical Mixing System (Optional)
The chemical mixing system is designed to automatically mix the
cleaning chemical directly from the manufacturer's chemical contain-
er into the clear water coming from the solution tank. The chemical
control knob on the control panel is used to select the desired ratio
according to the recommendation of the chemical manufacturer and
the application requirements. The ratio settings are shown in fi gure
19.
CAUTION: Do not operate the chemical pump dry.
If the chemical container is empty, make
sure the chemical control is in the off
position.
To operate the chemical mixing system, follow this procedure:
1. Select the proper cleaning chemical for scrubbing applica-
tion.
2. Set the chemical knob to the recommended setting per the
chemical manufacturer.
3. Make sure the recovery tank is empty and then open the
recovery tank.
4. Position the manufacturer's chemical container into the
bracket located at the front right side of the solution tank.
See fi gure 18A & 18B
5. Remove container cap and insert bottle adapter and
tighten cap.
6. Slowly close the recovery tank.
NOTE: With the knob turned fully counterclockwise, only
water will be delivered to the fl oor.
-18- FORM NO. 71483A
Figure 19
Clarke ®
Operator's Manual (EN) - FOCUS II MID-SIZE AUTOSCRUBBER
Figure 18A
Figure 18B
GREEN
BLUE
YELLOW
RED
®