Clarke Focus II Disc 34 Manuel D'utilisation page 14

ENGLISH
EN
HOW TO PREPARE THE MACHINE
FOR OPERATION
How To Install The Brush Or Pad (BOOST Machine)
To install the brush or pad on the machine, follow this
procedure:
1. Turn the key switch "ON".
2. Put the brush head assembly in the "Up" position.
3. Turn the key switch "OFF".
4. Go to the front of the machine.
5. Press on a brush or pad, under the fl ex plates.
See fi gure 10.
NOTE: When using a black pad, position pad on head. Lower head
and operate momentarily to affi x pad to pad driver (if you have
diffi culty, position pad on fl oor and lower head then operate.)
How To Remove The Brush Or Pad (BOOST Machine)
To remove the brush or pad from the machine, follow this procedure:
1. Turn the key switch "ON".
2. Put the brush head assembly in the "Up" position.
3. Turn the key switch "OFF".
4. Go to the front of the machine and pull downward on the brush or
pad until it releases from the fl ex plates. See fi gure 11.
-14- FORM NO. 71483A
Clarke ®
Operator's Manual (EN) - FOCUS II MID-SIZE AUTOSCRUBBER
Figure 10
Figure 11
®