Clarke Focus II Disc 34 Manuel D'utilisation page 20

ENGLISH
EN
HOW TO OPERATE THE MACHINE
How To Clean A Floor
WARNING: Water solutions or cleaning materials used
with this type of machine can leave wet areas
on the fl oor surfaces. These areas can cause
a dangerous condition for the operator or
other persons. Always put CAUTION signs
near the area you are cleaning.
To clean a fl oor, follow this procedure:
1. Set the parking brake (if equipped with machine.)
2. Put the water and a cleaning chemical in the clean solution
tank.
3. Release the parking brake (if equipped with machine.)
4. Turn the key switch "ON".
5. Lower the squeegee.
6. Press the one touch control button to lower the brush head as-
sembly and start vacuum motor.
7. Adjust the fl ow of clean solution to the fl ow desired.
8. Move the machine across the fl oor in the forward direction.
9. Make a 180° turn.
NOTE: When you make more passes across the fl oor, let the brush
clean approximately 2 inches (5 cm) of the area already cleaned by the
brush.
NOTE: During most cleaning procedures, apply and remove the solu-
tion in one operation.
How To Clean A Very Dirty Floor
To clean a very dirty fl oor, follow this procedure:
1. Apply solution to the fl oor.
2. Do not lower the squeegee. Shut vacuum motor "OFF".
3. Lower the brush or pad and scrub the fl oor.
4. Scrub the fl oor again with additional solution and lower the
squeegee and turn vacuum motor "ON".
5. Pick up all the solution with the squeegee.
-20- FORM NO. 71483A
Clarke ®
Operator's Manual (EN) - FOCUS II MID-SIZE AUTOSCRUBBER ®