Publicité
Les langues disponibles
Les langues disponibles
Allow the appliance to cool down for 2 to 4 minutes before using
it again.
TIPS
• The best result is achievement when using whole
milk.
• If the amount of milk of too low the result will not be
good less than 75 ml.
• The quality of the milk foam can vary between different
brands of milk. If necessary, experiment with other brands of
milk for a better result.
5
heating milk
Lift the lid and fit the mixer in the jug. Fill the desired amount of
milk into the jug. Do not exceed the maximum of the top max.
mark MAX
400 ml.
Put the lid back on the jug and place the appliance on the base.
Start the preparation by pushing the button
The red control light will burn and the mixer will start turning.
Depending on the filling volume, the preparation stops
automatically after 90 to 140 seconds. The control light goes
out.
After the preparation is completed, remove the lid upwards and
pour the hot milk into a cup. After having used the appliance,
clean it as described in the chapter Cleaning & Maintenance.
Allow the appliance to cool down for 2 to 4 minutes before using
it again.
6
Before cleaning always unplug the appliance and let it cool down
completely.
Clean the appliance immediately after every use.
Take the milk jug of the base and remove the whisk or the mixer
by pulling it straight upwards. Clean the milk jug, the lid, the whisk
and the mixer with warm soapy water. Dry the parts thoroughly.
Rinse the inside of the milk frother with hot water. Make sure you
remove all the milk residue from the inside. It is not hygienic and
can be harmful.
The parts cannot be cleaned in the dishwasher.
Never immerse the appliance, the power base, the power cord
or plug in water or other liquids.
Wipe the outside of the appliance with a damp cloth regularly.
.
cleaning & maintenance
11
English
•
Publicité
