Error remedy
Fault
Charging with suitable charging device
not possible
Battery has no voltage
Battery does not provide enough power.
© JUNG Hebe- und Transporttechnik GmbH
Electrically driven trolleys JLA-e 5/12 G, JLA-e 15/30 G and JLA-e 25/50 H
Possible cause
Excessive temperatures, protective electro-
nics triggered
Temperature too low (battery <1°C)
Battery already full
Other cause of error
Dead battery
Plugs or contacts defective or contaminated
Excessive temperatures, protective electro-
nics triggered
Defective fuse
Battery pack too old and consumed.
Protective electronics limit the power.
Solution
Allow the rechargeable battery to cool off
and reconnect the charging device.
Warm up battery slowly at 15-25°C, then
connect the charging device.
Disconnect charging device from battery.
Please contact Customer Service for more
exact information.
Disconnect battery from the consumer,
connect the charging device and allow it to
charge.
Check the poles of the battery and clean, if
necessary.
If the contacts are defective, please contact
Customer Service.
Allow the battery to cool off and put it back
into operation.
Please contact Customer Service.
Battery pack should be replaced.
Please contact Customer Service for more
exact information.
- 61 -