Charging The Steering Gear Battery - Jung JLA-e 5/12 G Mode D'emploi

4.4.7 Charging the steering gear battery

Variant A EU version
(JLA-e 15/30 G / JLA-e 25/50 H)
Variant B US version
(JLA-e 15/30 G / JLA-e 25/50 H)
Variant C
(JLA-e 5/12 G)
> To charge the battery, connect the cable (1) to the
charging socket.
© JUNG Hebe- und Transporttechnik GmbH
Electrically driven trolleys JLA-e 5/12 G, JLA-e 15/30 G and JLA-e 25/50 H
To recharge this lithium-ion battery, only charging
devices may be used which have been explicitly appro-
ved for this battery by the manufacturer. Using other
charging devices might destroy the battery.
The charging device is connected to the "Charging
device" connection. This connection has a pilot contact
and auxiliary contact, in addition to the main contact.
1
Once the charging device is connected, the BMS
(battery management system) is notified via the
auxiliary contact that a charging device is connected
to the battery. The BMS can now start charging. This is
done via the pilot contact. To send the start signal to
the charging device, a potential-free contact is closed in
1 1 1
the BMS.
The charging device controls the charging current on
its own and monitors the charging process. Charging
takes place in multiple charging phases, according to a
charging characteristic curve permanently stored in the
charging device. Hereby, the most important limit valu-
es, such as voltage, current and time of the individual
phases, are constantly monitored and evaluated.
If irregularities occur during the charge or if charging is
ended by the BMS, this potential-free contact is opened
and the charging process interrupted.
1
Do not charge the battery of the JLA-e 15/30 G and
the JLA-e 25/50 H from the side!
NOTE
NOTE
- 51 -