Zanussi ZEI3921IBA Notice D'utilisation page 5

CARE AND CLEANING
WARNING! Do not remove the
buttons, knobs or gaskets from the
control panel. Water may get inside
the appliance and cause damage.
• Clean regularly the appliance to prevent the
deterioration of the surface material.
• Deactivate the appliance and let it cool down
before you clean it.
• Disconnect the appliance from the electrical
supply before maintenance.
• Do not use water spray and steam to clean the
appliance.
• Clean the appliance with a moist soft cloth. Only
use neutral detergents. Do not use any abrasive
products, abrasive cleaning pads, solvents or
metal objects.
INSTALLATION
WARNING! Refer to Safety chapters.
BEFORE THE INSTALLATION
Before you install the hob, write down the
information bellow from the rating plate. The rating
plate is on the bottom of the hob.
Model .......................................
PNC .........................................
Serial number ...........................
BUILT-IN HOBS
Only use the built-in hobs after you assemble the
hob into correct built-in units and work surfaces
that align to the standards.
CONNECTION CABLE
• The hob is supplied with a connection cable.
• To replace the damaged mains cable use the
following (or higher) mains cable type:
DISPOSAL
WARNING! Risk of injury or
suffocation.
• Contact your municipal authority for information
on how to discard the appliance correctly.
• Disconnect the appliance from the mains
supply.
• Cut off the mains electrical cable close to the
appliance and dispose of it.
SERVICE
• To repair the appliance contact an Authorised
Service Centre.
• Use original spare parts only.
H05V2V2-F T min 90°C. Speak to your local
Service Centre.
INSTALLATION OF MORE THAN ONE HOB
min. 650 mm
If several 30 cm hobs are to be installed side by
side into the same cut out, an assembly kit
including a support side bracket and supplementary
seals is available at our Authorised Service
Centres. The relevant installation instructions are
supplied within the kit package.
490 mm
270 mm
5