Publicité
Les langues disponibles
Les langues disponibles
W 990 Flexio
W 990 Flexio
Problem
Spray jet is uneven/
not constant
The gun is "spitting"
Coating material
causes "paint tears"
Too much fog of
coating material
(Overspray)
Width of paint spray
cannot be adjusted
Poor covering
capacity on the wall
Coating material
cannot be atomised
23. Storage
Attention! Risk of damage due to freezing water. Store the device in a
frost-free place only once it has been completely emptied.
•
Store the device only when cleaned properly.
•
Release the trigger stop.
Cause
•
Air filter heavily soiled
•
Nozzle seal is missing or worn
•
Filter clogged at suction hose
•
Not enough paint in the
container (the pump has
sucked in air)
•
Too much coating material
applied.
•
Distance to the object too
large
•
Too much coating material
applied
•
Amount of air too high
•
Adjustment ring is not
connected to the peg on the
air cap
•
Air screen is clogged up
•
Spray material is too cold
•
Highly absorbent surface
or paint with poor covering
capacity
•
Distance too large
•
Turbine is defect
Remedy
➞ Change
➞ Replace
➞ Clean filter
➞ Refill the paint container.
Detach the spray
attachment from the
turbine unit and hold it
over the paint container.
Depress the trigger until
the paint jet is even
again.
➞ Reduce material volume
➞ Reduce distance
➞ Reduce material volume
➞ Decrease air volume
➞ Connect adjustment
ring and peg
➞ Disassemble and clean
➞ The material you are
spraying should be at
room temperature
➞ Cross spray (Fig. 20)
➞ Closer to the object
➞ Please contact Wagner
Service
GB
D
53
53
Publicité
