Elite Super Crono Hydromag Digital Mode D'emploi page 11

Finish a run
Once completed the run, it is possible to view
the maximum and average values for speed and
power, the elevation gain, the distance covered
and the duration of the run.
If you restart pedalling, the values of the run (ave-
rage and maximum values, time and distance) are
up-dated.
Delete data of a run
After two minutes of inactivity, which means there
is no pedalling motion nor pressing of the con-
sole keys, the program goes in "stand-by". Once
in "stand-by", all the information of the run just
completed are memorized.
To commence a new run and delete the previous
data, just proceed with the CLEAR procedure.
To start the CLEAR procedure, press the left (SET)
key for at least six seconds.
Attention: the trainer must not be running to be
able to delete data of a run.
For the first three seconds nothing changes.
Maintaining pressed the SET key, after the first
three seconds, CLEAR will appear on the screen.
This confirms that you are deleting the data of the
run just completed. To stop the delete procedure,
simply stop pressing the key.
After six seconds you kept the key pressed, CLEAR
and DONE will appear on the screen.
This confirms that you have deleted the data of the
run just completed, and you can now stop pres-
sing the key.
Shown below are the screens that appear during
this procedure.
3
Batteries
Two AA batteries are necessary to power Super
Crono Hydromag Digital. The life duration depends
on the quality of batteries used.
Battery life will last longer if you disconnect the
speed sensor plug from the shifting lever when
the trainer is not running. In normal conditions,
standard alkaline batteries should last for about
300 hours. Rechargeable batteries can be used
only if they are 1.5 V.
1 Supercrono HydroMag Dgt.indd 11
When the batteries are running
down a battery symbol will start
flashing on the screen. From
when the symbol starts
flashing the batteries still have
several hours of life.
When the batteries completely
run down the screen will turn
off, while the program will save
all the data in it's memory. With the replacement
of the batteries all the data stored will be saved.
With the possibility of storing information, Super
Crono Hydromag Digital can remain without power
for long periods without losing any data.
Attention: Throw away run out batteries in ap-
propriate containers.
Troubleshooting
1. While pedalling, the values on the LCD screen
representing speed, power, time and distan-
ce don't up-date as they should (in the current
screen, speed and power values are zero while
the others don't change).
Probably the information from the sensor placed
on the resistance unit doesn't arrive to the console.
Check that the speed sensor and the plug are pro-
perly fixed.
2. All the values on the LCD screen are correct but
the resistance level indicator, which indicates the
resistance level/gear shift position, remains
blocked on the first level even if I change gear.
Probably no information arrives from the sensor
of the gear shift. Check the cable from the console
to the lever.
3. The slope values are different from yesterday.
The slope value is in function of the weight, thus
every time you introduce a new weight value, the
slope figure for each resistance level will automa-
tically change.
4. The slope value is too high.
seconds
6
Check the weight value (see paragraph Set up
settings Instructions). In fact the slope value is
inversely proportional to the rider's weight and
if the weight value is too low, the slope value is
wrong.
5. The speed value is too high and the other values
are incorrect.
Probably the model of resistance unit selected is
not Super Crono Hydromag Digital. Check the SET
UP fase that the TYPE value is "2".
GB
11
05/11/09 12:21