EUROM 342192 Manuel D'utilisation page 40

Press the button again and the heating will

switch on, on low power. The display will
show Fig. B.
Press the button a third time and the heating

will switch to full power. The display will show
Fig. C.
Press the button a fourth time and the swivel

function switches on. The display continues to
show Fig. C.
Press the button a fifth time and the unit

returns to standby (S). The unit will cool down for 30 minutes.
You can set a delayed start time using the timer button

standby (S) and press the timer button. Each time you press the timer button,
one hour is added to the start time. The display shows the number of hours set
and counts down at the end of each hour. The timer lamp also switches on. The
unit starts automatically at the end of the set time. The standard temperature is
23°C (note it is not possible to set the thermostat using the buttons).
If the weekly programme is not set and if no temperature has been set using the

remote control, the unit will switch off automatically after 12 hours.
Operation using the remote control
Please note: the remote control only works if the emitter on the
remote control can make contact with the receiver on the unit.
Make sure that the unit is in standby mode (S) (use the main

switch).
Press the power button

display will show Fig. A.
Press the function button

power. The display will show Fig. B.
Press the button again and the heating will switch to full power.

The display will show Fig. C.
Press the function button a third time and the unit will return to

mode A.
If you press the swivel button

flap will move up and down, changing the direction of the air. Press the swivel
button again to turn this function off.
The timer button

button on the unit.
Set the day and time:
Make sure that the unit is in standby mode (S) (use the main

switch). You can also set the day and time while the unit is
switched on.
Press the SET button

the plus and minus buttons
23). Press SE T again to see the minutes. The display shows "30"
to switch the ventilator on; the
to switch the heating on, on low
while one of the three functions is set, the
on the remote control works in the same way as the timer
once; the display now shows "12". Use
/
40
to set the hour (from 1 to
. Set the unit to