Publicité
Les langues disponibles
Les langues disponibles
Location and Connection
Remove all packaging material and keep out of reach of children. After removing
packaging, check the appliance for damage or other signs that could indicate a
fault/defect/malfunction. In case of doubt, do not use the appliance, but contact
your vendor for inspection or replacement.
Select a suitable location for the device taking into account all the
aforementioned warnings in this manual.
The device has to be hung from a wall and therefore may not be used in a lying,
leaning, hanging or standing position! The wall on which the device is hung has
to be firm, flat and perfectly vertical and made from non-inflammable material
that cannot melt. It has to be at least 20 cm away from side walls and the top
has to be at least 180 cm above the floor.
The heater has to preferably be positioned at and permanently connected
to an electric socket. This connection may only be made by a qualified
electrician and, for that reason, is not described here. In this manual, for
reasons of safety, use with a plug should be assumed; when there is a
permanent connection, any passages about the plug do not apply.
Drill two holes in the wall at the required locations, to fit the plugs exactly: make
sure these holes are horizontal and 39.4 cm apart. Insert plugs and screws into
the holes. Allow the screws to stick out by 10 mm. Hook the heater over the
screws using the hanging eyes, then slide to the left and pull downwards. The
fixing material supplied is suitable for brick walls. Consult a specialist, for
instance at a DIY store, if your wall is built of other
material.
Check whether the heater is secured to the wall; if
necessary insert the screws a little further into the
plugs.
Attach the heater using the materials supplied. Place
the bracket on top of the heater (see picture) with the
short side against the wall. Mark the location of the
hole on the wall and remove the heater. Drill a hole at
the marked spot and insert a plug. Now hang the
heater in place and screw the bracket to the wall, as shown in the diagram. The
heater is now installed.
Using for the first time and operation
Make sure that the main switch is OFF (O)
Unroll the electrical cable entirely and insert the plug into a suitable
220/240V socket.
Set the main switch to ON (l). The display will show "S" (standby).
Manual operation using the buttons
Press the F button once. The ventilator will switch on and the display
will show Fig. A.
39
Publicité
