Refco 4688098 Mode D'emploi page 25

REFMATE operating instructions

Copy the received file from your email to the new drive.
Switch off the REFMATE
 Start the REFMATE by pressing and holding the
following key combination:
First
until the display switches on.

The current firmware is deleted from memory and the
new firmware is installed. Duration: approx. 1.5 min
8 Troubleshooting
Problem
No temperature is
displayed
Pressure is displayed
incorrectly and can no
longer be set to 0 in
atmosphere
Battery life is not
sufficient for testing
No recording is
displayed
SD card is not being
read
and then
Action
Measuring range exceeded
Change area of application or
replace the temperature
sensors
Calibrate the pressure sensors
Power the device via USB with
a power bank or power supply
unit with USB connection
No memory inserted
Micro SD card must be inserted
before switching on
Micro SD card memory is full
Use a high-quality industrial SD
card. Support will be given to:
• SDSC bis 2GB
.
simultaneously for one second
English
23