Refco 4688098 Mode D'emploi page 103

Istruzioni per l'uso REFMATE Italiano
6.1.6 Menu
Campo Calibrazione con
pressione di referenza
Zeroing the pressure sensors
Press and hold The
pressure can also be zeroed in
the menu with zeroing the
pressure and press .
Pressure calibration
In the navigation, go with
to and press . Use the
tab to carry out the field
calibration of the pressure
sensors.
To start the calibration, enter
the PIN. The PIN is 0-0-0-9
The device must not be
pressurised at this time!
Press when activated
Connect the device to a
system with a defined
pressure.
Pressure range: 10–60 bar
The higher the calibration
pressure, the more accurate
the calibration!
Wait until the calibration
pressure corresponds to the
reference pressure. By clicking
the respective pressure
sensor is calibrated.
101