Korg EFGSJ 6 Manuel D'utilisation page 20

13. Lift up either the left or right side of the stand to insert
the pedal unit into the pedal board.
Rear
Push
Front
14. Insert the pedal unit into the pedal board, and then fas-
ten it by pressing a push rivet into the hole (above the
cutout) at the rear of the pedal board.
After installation, lift the stand to check that the pedal unit
does not fall out.
The push rivet will prevent the pedal unit from falling out.
Therefore, it cannot be fully fastened to the pedal board.
15. Firmly tighten the pedal board and rear panel screws
temporarily tightened in steps 4 and 10.
When tightening the screws on the G1/G1 Air, adjust the
up/down and front/rear positions on the left and right side
panels so that they are equal.
16. Make sure to attach the anti-tipping brackets behind
both side panels. And the anti-tipping bracket fastened
to the left of the code holder at this time.
Attach the anti-tipping brackets, starting with the round
hole at the bottom.
Joints between the side panels and the attached anti-tip-
ping brackets should be even (with no level difference left).
Reverse
Cord holder
Screws (M4, short)
17. Ensure that the stand has no gaps and is not tilted, and
that all the screws are tightened firmly.
18. Connect the AC adapter (refer to "Connecting the Pow-
er" on page 5), pedal cord and the speaker cord to the
Connector Panel at the center of the underside of the key-
board unit.
When connecting the pedal cord and the speaker cord, ob-
serve the correct orientations of the connectors.
The pedal cord or the speaker cord can be detached from the
connector with its locking tab held down.
20
Rear of pedal board
Push rivet
Anti-tipping
Brackets
Reverse
Screws
(M4, short)
Locking tab
Speaker cord
AC adapter cord
19. Use the two cord holders to secure the AC adapter cord
and pedal cord.
After securing the cord with the cord holder, ensure that
excess pressure is not applied to the connectors.
20. Place the G1/G1 Air where you intend to use it. Make
sure to place it in a safe location where the floor is flat
and stable.
When setting the digital piano in place, make sure
that the stand does not rest on the AC adapter cord or
pedal cord.
For greater safety, be sure to attach the anti-tipping
brackets to the rear of the left and right side panels.
Check following assembly
□ Are any parts left over?
If any parts are left over, carefully review the assembly
procedure to see where those parts should have been used.
□ Make sure that all screws are tight.
Pedal cord
Cord
holder