Korg EFGSJ 6 Manuel D'utilisation page 19

7. Align the bracket holes in the left and right side panels
with the holes in the speaker box, and then secure them
with the four screws (M4, long) so the gaps on the left
and right sides are equal.
At the same time, secure the cord holder with the top screw
on the left side panel.
Screws (M4, long)
8. Attach the brackets at the holes (under the speaker box)
in the left and right side panels with the screws (M4,
short).
Screw (M4, short)
Bracket
9. Slightly bend the rear panel and insert it into the grooves
in the left and right side panels.
Be careful not to pinch your fingers.
Rear panel
Bracket (A)
Dent
Speaker cord
Cord
holder
Screws
(M4, long)
Bracket
Screw (M4, short)
Grooves
10. Lift up the rear panel to align the holes in the rear panel
and the brackets installed in step 8, and then temporarily
fasten the bottom of the rear panel with the four screws
(M4, short).
Bracket
Hole in the rear panel
Rear panel
Screws (M4, short)
11. Fasten the rear panel and the brackets (through the holes
aligned in step 10) with two screws (M4, short).
Screw (M4, short)
12. Connect the attached pedal cord, observing the correct
orientation, to the connector on the reverse side of the
pedal unit, and then engage it with a slot in the pedal
unit.
The pedal cord can be attached to or detached from the
connector with its locking tab held down.
Screws (M4, short)
Screw (M4, short)
Locking
tab
19