Publicité
Les langues disponibles
Les langues disponibles
ASSEMBLY AND
INSTALLATION
Please refer to the illustrations
(R to Y) provided at the front and
back of this manual.
For more information about instal-
lation, see also
www.ritterwerk.de/
installation-notes.
Safety instructions
To avoid personal injury or dam-
age to the appliance, please
observe the following safety
instructions:
– This appliance may only be
assembled by qualified person-
nel. ritterwerk will not be held
liable for the consequences
of improper and/or incorrect
assembly.
– The power cord must be posi-
tioned to ensure that the appli-
ance can be fully folded down
into the drawer without the
cable becoming trapped. The
power cord must be routed
directly and without obstruc-
tion from the built-in system
to the socket, which must be
mounted in the floor unit.
– Unplug the cable from the
socket before assembly.
Installation conditions
The following dimensions repre-
sent minimum values:
– Drawer clearance width:
184 mm,
– Clearance height for drawer
base/ crossbeam:
80 mm (not allowing for stor-
age of the slice tray)
85 mm (allowing for storage of
the slice tray)
– Pullout clearance for front
edge of worktop/inner edge of
front drawer panel: 412 mm
– Width of appliance (when
folded down): 195 mm
The drawer base should be at
least 16 mm thick.
At a nominal length of 500 mm,
the drawer runners should have
a static load capacity of at least
30 kg.
Delivery contents
14
Clamping fixture (front)
15
Clamping fixture (rear)
16
Lock clip
16a Slide bar lock
17
Countersunk screws four
4 x 17
18
Countersunk screws two
3 x 16
Selecting a socket
Note:
A surface-mounted socket (that
complies with VDE/DIN 49440,
ÖVE, SEV) must be mounted
either on or behind the rear
panel at drawer height.
The power cord connection to the
socket should be routed under
the rear crossbeam or the under-
side of the work top and as high
up as possible in the corner of the
floor cabinet's rear panel.
It must be possible to slide the
drawer in fully while the power
plug is in the socket.
The power plug must be eas-
ily accessible to the user to
ensure that the appliance can
be unplugged from the mains as
required (for example, prior to
cleaning).
Mounting the food slicer
• Pull out the drawer until it
stops.
R
Place the drill template in the
drawer as shown in the illustra-
tions.
• Mark the positions for the four
drill-holes required.
• Use a 1.5 mm drill to pre-drill
the marked positions.
S
Use the four countersunk
screws provided (17) to bolt down
the two clamping fixtures (14
and 15).
• Use the two countersunk
screws provided (18) to attach
the lock clip (16), together with
slide bar lock (16a), to the front
clamping fixture (14).
• Leave the lock clip open.
T
Pull out the pull-out fitting on
the multi slicer.
U
Position the multi slicer over
the two clamping fixtures in the
drawer.
V
Slide the multi slicer towards
the front of the drawer until it
locks into place on the two clamp-
ing fixtures.
W
X
/
Press down on the lock
clip until it snaps into place.
• Plug the cable into the socket.
English
15
Publicité
