Franke COUNTRY FLAT CF 65 M F Serie Manuel D'installation Et Mode D'emploi page 15

SGP 62 M _/F / SMP 62 M _/F / SMP 66 M _/F / CF 65 M _/F
Removing the oven door (Fig. 3)
To facilitate oven cleaning, the oven door can
be removed by operating on the hinges as
follows:
X X
The hinges are equipped with two moveable
locks (A). Lift the lock (A) to release
the hinge.
X X
Then lift the door up and pull it outwards; to
do this, hold the door at the sides near
the hinges.
X X
To refit the door, first slide the hinges into
their grooves.
X X
Before closing the door, remember to
turn the two locks (A) used as hinge
attachments.
Refer to the pictures at the end of this manual.
TECHNICAL DATA
Power supply voltage and frequency
Total power and fuse rating
Power and heating elements
Upper
Lower
Grill
Fan
Tangential fan
Oven lamp
Replacing the oven lamp
A
X X
Turn off the power to the appliance by
means of the omnipolar switch used for
connecting it to the electrical system, or
disconnect the plug if accessible.
X X
Unscrew the glass cover (A).
X X
Unscrew the lamp and replace it with one
resistant to high temperatures (300 °C),
with the following characteristics:
– Voltage: 220/240 V ~ 50-60 Hz
– Power: 25 W
– Connection: G9
X X
Refit the glass cover (A) and reconnect the
power supply.
220-240 V, 50/60 Hz
2300 W ~ 16 A
1000 W
1250 W
2250 W
30 W
15 W
1 x 25 W
– 15 –
Franke ovens are
equipped with a
circular lamp
positioned in the top
left area at the back
of the compartment.
To replace the oven
lamp, proceed as
follows:
EN