Becker CentronicPLUS SC911 PLUS Notice De Montage Et D'utilisation page 24

Sensor assignment with the hand-held transmitter
3s
Assignment status
Lights up yellow:
Lights up blue:
Lights up green:
Lights up white:
Lights up purple
Lights up red:
24 - en
Bring the transmitter as close as possible to the required sensor.
Press the programming button on the transmitter for 3 seconds. The
transmitter performs a search and the LED ring continuously changes
colour. The transmitter then switches to receiver selection and selects
the sensor/receiver with the best connection quality.
▻ The sensor/receiver confirms.
If you do not receive confirmation from the required sensor, you can
press the / button to toggle between the available sensors/receivers
until the indicator lamp on the required sensor flashes 3 times to
confirm.
▻ The transmitter displays the current assignment status via the
LED ring.
The sensor/receiver is not yet part of the installation or
is in the as-delivered condition.
Briefly pressing the STOP button adds the device
to the installation and updates the assignment
status.
The receiver is not assigned to the selected chan-
nel.
The receiver is assigned to the selected channel.
Centronic PLUS sensor selected.
Centronic PLUS transmitter selected.
No receiver located.