Becker CentronicPLUS SC911 PLUS Notice De Montage Et D'utilisation page 23

With an SWCxxxPLUS transmitter
With brand new products, devices from another installa-
tion or products that have been restored to factory set-
tings, programming mode must be established before-
hand (see Establishing programming mode).
3s
Assignment status
Lights up yellow:
Lights up blue:
Lights up green:
Lights up white:
Lights up red:
3s
Bring the transmitter as close as possible to the sensor to be pro-
grammed.
Press the programming button on the transmitter for 3 seconds. The
transmitter performs a search and the LED ring continuously changes
colour. The transmitter then switches to receiver selection and selects
the sensor/receiver with the best connection quality.
▻ The sensor/receiver confirms.
If you do not receive confirmation from the required sensor, you can
press the / button to toggle between the available sensors/receivers
until the indicator lamp on the required sensor flashes 3 times to
confirm.
▻ The transmitter displays the current assignment status via the
LED ring.
The sensor/receiver is not yet part of the installation or
is in the as-delivered condition.
Briefly pressing the STOP button adds the device
to the installation and updates the assignment
status.
The receiver is not assigned to the selected chan-
nel.
The receiver is assigned to the selected channel.
Centronic PLUS sensor selected.
No receiver located.
Press the STOP button on the transmitter to change the assignment
status of the selected receiver. If the receiver is still not assigned to the
selected sensor, it will now be added.
▻ The sensor lights up accordingly to confirm the new assign-
ment status.
▻ The sensor is now part of the installation.
Then press the programming button on the transmitter for 3 seconds to
change to normal mode.
► The indicator lamp goes out.
23 - en