Theben HTS ECO-IR 180EIB-AC Notice D'utilisation page 50

2. Walking test – LED on when motion is detected
● The walking test begins after the identification phase. It allows the user to
check presence detection and parallel connection of multiple detectors.
● The „Light" and „HVAC" switch-off delays are shortened to approx. 10 or
20 seconds. Should somebody be in the detection range, the lighting will
stay on.
● When the person has left the detection range the lighting will go out after
10 seconds.
● The LED will come on as soon as a detector senses a movement
● The buttons are in Function
During the walking test the detector work in full automatic

mode. Brightness measurement is disabled. The detector
only reacts to motion.
6.1 Regular Operation
● Regular operation is not possible in „test" mode. Select „Run" mode.
● Push the detector safety lock completely in after the test (between the
sensor unit and bus interfaces). Afterwards the detector will be ready for
operation.
0