Theben HTS ECO-IR 180EIB-AC Notice D'utilisation page 47

Potentiometer:
● Default setting of potentiometer is in middle position.
.3 „Run" mode (default setting)
In „run" mode the detector runs through three phases, which are displayed
by a LED behind the sensor lens, whenever it is plugged in:
1. Start-up phase (0 sec.)
2. Service phase (10 min.)
3. Operation
Do not exert any undue force when coupling! Make sure it is

correctly positioned. Do not press on the lens. Only hold the
sensor unit only by he white frame.
1. Start-up phase - LED blinks once a second.
● After inserting (start-up phase) or after programming the unit, the swit-
ched outputs send a „on" message.
● The push buttons are not operational yet.
● Fast blinking (4 times a second) means: no or wrong application.
Check the compatibility of the sensor unit, BCU and application.
● The start-up phase lasts 90 sec.
GB