Start-Up Procedure - Theben HTS ECO-IR 180EIB-AC Notice D'utilisation

. Start-up procedure

.1 Remote Parameter Setting Via ETS
All settings are made via the ETS (see „KNX/EIB Product Database - Out-
line"). They can be changed at any time.
.2 Local Settings
The local settings of the potentiometers and DIP-switches are only active, if
they are enabled on the ETS. The setting range is limited. The „run – test"
DIP-switch is always active.
DIP-switch:
● The operating mode and the range of the brightness switching levels can
be varied on a DIP-switch (only active when enabled by the ETS).
Lux normal
*) «wide»: Lux scale for low switching levels extended;
Potentiometer on the right limit stop: Light measurement deactivated,
light always switches on detecting a presence.
6
left right
norm wide
run
test
Lux extended*