Valor LT1 Serie Guide D'installation page 2

Installation
1. Locate the trim inside the perimeter of appliance's
opening and press it firmly against the cement
board or wall finish.
2. Secure the trim using 4 no. 8 screws.
3. Place the cover plate in the space between the glass
and the trim. Align the round notch of the plate to
the hole in the support underneath as shown.
Note: Each end of the plate has a rounded notch
opening to insert the hinge pin of the side doors.
2
Align notch in plate
with hole underneath
4. Identify the left-hand door according to the images
below.
Left Door
Front
5. Insert the top hinge pin into the upper hole behind
the frame.
6. Lower the bottom hinge pin into the bottom hole.
7. Repeat for the right-hand door.
Insert hinge
pin here
hinge
hinge pin
pin
hinge pin
Top of door:
Longer hinge pin
Bottom of door:
Shorter hinge pin
Rear
Insert hinge
pin here
Insert hinge
pin here