Publicité
Les langues disponibles
Les langues disponibles
Motor wires x 3
Power Switch & Set button
Input Voltage
Throttle
Setup
1. TX in neutral - press set
button (1 Green flash)
OM
Electronic Speed Controller (ESC)
Only use fully charged LiPo batteries (4.2V per cell) to prevent
battery/ESC damage.
Battery Plug
3S-4S LiPo (11.1-14.8v)
35C 5000mAh Minimum Req.
Connect batteries, turn on TX and press/hold the set button 'A'. Turn the switch on
'B' and release the set button when the RED light flashes on the ESC.
2. TX full throttle - press set
4. Switch off ESC to complete setup
www.modellmarkt24.ch
ESC Specifications
button (2 Green flashes)
17
WARNING: Heat sink
may be hot after use.
Receiver Plug (CH2)
BEC Output 6.0v/4A Max
3. TX full brake - press set
button (3 Green flashes)
A
WWW.ARRMA-RC.COM
B
Publicité
