Yamaha MFC05 Manuel De L'utilisateur page 2

PROGRAM CHANGE NUMBERS TRANSMITTED WHEN
BANK A AND BANK B ARE SELECTED
FOOTSWITCH BANK A BANK B
1 1 6
2 2 7
3 3 8
4 4 9
5 5 10
If, for example, BANK A is selected (the LED above "A" is
it) and you want to select program number 9 on the receiving
device, simply press the bank select footswitch to select BANK
B (the LED above "B" will light) and then press program
change footswitch t4.
NOTE: No program change number is transmitted when the
bank select footswitch {A/B) is pressed. A program
change number is only transmitted when one of the
program change footswitches (1—4) is pressed
4, BATTERY INSTALLATION
The MFCOS requires 6 "AA" type dry batteries if you intend
to operate it without the PA-1 (B) AC adapter. Alkaline type
dry batteries are recommended because of their longer life.
@ Make sure the MFC05 power switch is OFF
© Use a coin or similar object to turn the large screw retaining
the battery compartment cover on the bottom panel of the
MFCOS, and remove the battery compartment cover.
@ Remove the battery holder, taking care not to pull on or
damage the battery wires. Unsnap the battery holder from
the battery clip.
@ Install the six batteries in the battery holder, making sure
that each battery faces in the proper direction. Battery
orientation markings are provided on the battery holder.
®© Snap the battery clip securely back onto the battery holder,
and replace the battery holder in the battery compartment.
@ Replace the battery compartment cover and tighten the
retaining screw.
NOTE: When 'the batteries need replacing, the MFCOS
indicators will begin to flash. When this happens,
replace all six batteries at the same time. New
batteries should never be mixed with old ones.
NOTE: When performing, it's a good idea to have a spare
set of batteries handy —just in case.
NOTE: It is a good idea to have a fresh set of batteries
installed even when using the PA-1 (B} AC adapter.
If the AC adapter cord is accidentally unplugged
during use, the MFCOS will instantly switch to bat-
tery power
NOTE: Even when no batteries are installed, make sure to
attach the battery clip to the battery holder. If this
is not done, the battery clip can come in contact
with a conducting surface inside the battery com-
partment, thus shorting the power supply and
possibly causing damage.
5. SPECIFICATIONS
Transmitted Data MIDI program change messages
1 through 10
Channel 1 only
A,B, 1, 2, 3, 4, 5.
AIB, 1, 2, 3, 4, 5, POWER.
MIDI OUT, DCSV—12V IN.
AA dry batteryx 6, or PA-1/
PA-1B AC adapter.
Approximately 10 hours con-
tinuous (alkaline batteries).
444 mm x 41 mm x 130 mm
(17-1/2" x 1-5/8" x 5-1/8")
Weight 1.2 kg. incl. batteries.
Supplied Accessories One set of six AA batteries.
Optional Accessories PA-1/PA-1B AC Adapter.
MIDI Transmit Channel
indicator LEDs
Switches
Connectors
Power Source
Battery Life
Dimensions {W x H x D}
6. MIDI DATA FORMAT
1. TRANSMISSION CONDITIONS
PROGRAM CHANGE sch > mi OUT
2. TRANSMISSION DATA
Channel Information {Channel Voice Message)
® PROGRAM CHANGE
Channel number fixed at channel 1
STATUS 11000000 (COH)
PROGRAM NO. 0000pppp p=0 (program no. î)-
9 {program no.10}