Publicité
Les langues disponibles
Les langues disponibles
ACT™ Conversion
Some local codes limit the maximum amount of CFM an insert can move. ACT™ allows you to control
the maximum blower CFM of select Zephyr Ventilation inserts without the need for expensive make
up air kits. ACT™ enables the installer to easily set the maximum blower speed to one of two most
commonly specified CFM levels, 390 or 290 CFM. The usage of ACT™ may not be necessary for your
installation. Please check your local codes for CFM restrictions.
performing the conversion instructions listed below. Failure to do
so could result in personal injury or damage to the product.
After re-positioning the jumper and powering on the insert, the
22
CAUTION
Insert must be disconnected from the main power prior to
CAUTION
CFM cannot be changed again.
Tornado Glo Use, Care, and Installation Guide
C O R E
TO R N A D O G LO
I N S E R T
Publicité
