Publicité
Les langues disponibles
Les langues disponibles
Features & Controls
Touch Controls
Mesh Filter Clean Reminder
An aluminum mesh filter is fitted by the factory, this filter is intended to filter out residue
from cooking. The filter need not be replaced on a regular basis but are required to be
kept clean. The Mesh Filter Clean reminder function in the microprocessor will automat-
ically indicate by a flashing
hours of use. Filter can be cleaned by hand with non-abrasive soap or in a dishwasher.
Heavily soiled filter should also be soaked in grease cutting detergent prior to cleaning.
Mesh Filter Clean Indicator
F
When
flashes on the display, the filter
needs to be cleaned. This will occur after
every 60 hours of use.
Reset the filter clean reminder timer after
filters are cleaned and re-installed. With
hood off, press and hold
mately 5 seconds until
disappears
function is now reset and a new 60 hours
elapse cycle is initiated.
Clean Air Function
Clean Air is a feature that turns on the blower on low speed every 4 hours for 10 minutes
to remove stagnant air in the kitchen. The Clean Air function is disabled by default and
must be enabled by the user.
Clean Air Indicator
While Clean Air is active, the display will
alternate between
After 10 minutes of Clean Air operation, the
blower will power off and the 4 hour timer
will reset.
If the blower speed is changed while the
Clean Air Function is in use, the cycle will be
interrupted and the timer will reset after.
18
when the filter need to be cleaned after every 60
F
for approxi-
F
on display
. The filter clean reminder
A
1
A
1
,
,
,
.
Clean Filters
display < F > flashes
To Reset
hold 5 sec.
display from < F > to < >
To Enable
hold 3 sec.
and
To Disable
hold 3 sec.
and
Tornado Glo Use, Care, and Installation Guide
TO R N A D O G LO
F
F
display < A > flashes
A
display from < A > to < >
A
C O R E
I N S E R T
Publicité
