Publicité
Les langues disponibles
Les langues disponibles
Features & Controls
Touch Controls
16
1. Power On/Off
By pressing
the last retained blower fan speed and lights are
switched on and off.
ACT Verification
- Airflow Control Technology (ACT) allows the installer to set the
maximum blower CFM to align with local codes and regulations.
- To verify the maximum blower CFM:
- With hood off, hold the
6 displays = default max. CFM, if number 3 displays = max. 390 CFM,
and if number 2 displays = max. 290 CFM.
2. Speed Selection
- Press
to decrease fan speed. 6, 5, 4, 3, 2, 1.
- If fan is on Speed 1 and
- Press
to increase fan speed. Fan On, 1, 2, 3, 4, 5, 6.
- If hood is off and
ACT Enabled Speed Selections
- When ACT is enabled, the number of blower speeds will be
reduced as follows:
- 390 CFM = Maximum 3 speeds
- 290 CFM = Maximum 2 speeds
3. Delay Off
This feature is used for programmed shut down of blower 5 min-
utes after the function is activated. Press once, a dot flashes
the lower right side of display
blower will completely shut down after 5 minutes.
4. Lights Low/High/Off
Switch lights on to low by pressing
high and again to shut off lights.
5. Display Window
The display window indicates speed levels and features such as
baffle filter clean reminder, delay off and clean air indicator.
Tornado Glo Use, Care, and Installation Guide
button for 3-4 seconds. If number
is pressed, the fan will power off.
is pressed, the fan will turn on speed 1.
indicating the function is on. The
once, press a second time for
C O R E
TO R N A D O G LO
I N S E R T
in
Publicité
