Danfoss RET1001M-V2 Guide D'installation page 4

Installation Guide
1 . Installation Steps
EN
1 . Installation must be done by an authorised
electrician .
2. The room thermostat should be installed at
approx. 1.5 m above floor and where the effects of
sunlight, draught or other heat sources (eg. TV's)
are avoided, see fig. 1. on page 44.
3. First loosen lower retaining screws and carefully
remove back plate, see fig . 2 on page 44.
4. Mount back plate direct to wall or on wall box and
wire according to application, see fig. 3 on page 44
& fig. 5 on page 45 according to application.
5. Locate hooks at top of front part into top of back
plate and lower into position and tighten retaining
screws.
2 . Dimensions and Wiring
See fig. 4 for dimensions and fig. 5 for wiring
diagram on page 45.
3 . LED indicators
Power on - Green
Thermostat Output on - Red
4 RET1001M - V2