Novy Pureline Frame 15001 Mode D'emploi page 40

Change in colour temperature with LED-lighting
First make sure that the power supply of the hood has
been disconnected. Remove the plug from the hood or
switch off the power group.
The colour of the LED-lighting has been set to 2.700 K
(warm white) by default. If the colour is to be changed to
4.000 K (neutral white), follow the instruction given below:
− Open the bottom panel at the bottom of the hood.
− Press with two hands against the side of the inox lamp
holder and carefully pull down simultaneously, so you
get access to the lighting on the inside.
− The wiring has been connected to the LED-lamp with
a connector.
− Disconnect the connector from the LED-lamp and move
the wiring to the other free connection on the lamp.
− Repeat this for all four LED-lamps.
− Then close the inox lamp holder again.
The colour of the LED-lighting has now been changed
from 2.700 K to 4.000 K.
3.6 recessed spotlight in shelf (if applicable)
Replacing the recessed spotlight in the shelf (only
applicable to 3 and 4 frame models)
First, make sure that the cooker hood is de-energised and
allow the lights to cool down sufficiently.
1. Removing the recessed spotlight
From the underside of the shelf, carefully
pull the edges of the recessed spotlight
to release it. Remove the spotlight by
rotating it downwards in an anti-clockwise
direction. Make sure that the connectors
and lighting cables come down from the
spotlight opening in the shelf.
Colour temperature 2,700K (warm white)
or 4,000K (neutral white) depending on
connection choice.
Red connection = 2,700K
Blue connection = 4,000K
Ensure that all recessed spotlights are connected in the
same way to prevent any difference in colour temperature.
2. Release the recessed spotlight:
A. Note the colour of the connection to which the recessed
spotlight is attached.
B. Disconnect the connector of the recessed spotlight to
be replaced from the lighting cable on the shelf. Press
slightly on the connector's locking tab and pull the
connectors apart.
3. Installing the new recessed spotlight:
A. Connect the correctly coloured connecting cable from
the recessed spotlight to the light cable.
B. Carefully push the new spotlight into the opening in the
shelf, making sure that the light cable/connectors are
not trapped between the spotlight and the shelf. This
is easier if you squeeze the springs together.
C. Then reconnect the power supply.
3.7 Change the batteries
− For changing the batteries unscrew the plastic
cover, remove the old batteries and insert
the new ones. Pay attention to the polarity
marking given in the battery compartment.
− Empty batteries are not to be disposed of
in the household refuse, but they are to be
handed in as chemical waste.
Technical information
− Power supply: 2xAAA batteries
− Frequence: 433.92Mhz
− Numbre of codes: 10
− Worktemperature: 0-50°C
− Dimensions: 110 x 50 x 19mm
3.8 Faults
If there is a fault you can contact your (kitchen) supplier
and/or Novy Customer Service.
Belgium Tel.: +32 (0)56 36 51 02
France Tel.: +33 (0)3 20 94 06 62
Germany Tel.: +49 (0)511 54 20 771
The Netherlands Tel.: +31 (0)88 011 91 10
Unite Kingdom Tel.: +44 (0) 207 866 2493
Italy Tel.: +39 (0)39.20.57.501
For all other countries: your local installer or
Novy in Belgium: +32 (0)56 36 51 02
To be able to deal with the fault promptly and efficiently it
is necessary that the Repaired Service knows which type
of appliance you have.

You can find the type number on a sticker in
the inside of the extractor hood. This becomes
visible as soon as you take the filter out of the
extractor hood.
You can note the type number here:
– 40 –