Publicité
Les langues disponibles
Les langues disponibles
Extractor power level
To increase the power level press key
To decrease the power level press key
− Three green LEDs
5
show positions one to three.
6
− The red LED
shows the Power position. The Power
position is only used if there are strong odours, or a lot
of smoke or vapour. Its use must be kept to a minimum
because of the large extraction of air in this position.
− The Power position automatically goes back to speed
three after 6 minutes.
− The motor has a thermal switch that switches the motor
off with overheating. After cooling the motor will switch
on again.
Determining the cause of overheating is re-
quired. This can be caused for example by a
pan fire, the impeller motor being blocked or
an object getting in the exhaust opening and
causing it to be partly or fully blocked.
Auto-Stop
To avoid the extractor hood from staying on, the motor is
automatically switched off after 3 hours (only if in 3 hours
operation has not been changed). The extractor hood
lighting stays on.
2.3 Lighting
Turning the lighting on and off
To turn the lighting on or off press
The light works independent of the motor.
The additional lighting in the shelf(s) works at the simul-
taneous time of the lighting in the cooker hood. There is
no additional lighting in the 2-frame version.
The LED lighting has a soft on/soft off mode, which means
that the lighting will evenly go on and off. When switching
on the lighting, this will always light up with full power and
it can also be used when the fan is off.
.
3
.
2
.
4
– 36 –
Dimming LED lighting
When the LED lighting has been switched on, it can be
dimmed by keeping key
Change in colour temperature with LED-lighting
You can change the colour temperature of the LED-lighting
form 2.700 K (warm white) into 4.000 K (neutral white). The
description for changing this can be found in section 3.4.
2.4 Remote control
➀ Lighting
➁ Increase speed levels
➂ Decrease speed levels
➃ Switch on / off
➄ Novy button: not applicable
The remote control for hood is preinstalled and ready for use.
Change the code on the remote control
If the set code disrupts other transmitters, another code
can be selected using the remote control. There are 10
different codes.
Determine the code used
Simultaneously press
and
control flashes as many times as the selected code (there
are 10 code options in total).
Change the code
− Simultaneously press and
− The green light on the remote control flashes as many
times as the selected code. If another code is required
repeat this step again (1x flashing is code 1, 2x flashing
is code 2 etc. There are total of 10 codes).
− Simultaneously press on the cookerhood
until the second green Speed indicator lamp is blinking.`
− Press the key
on the remote control within 10 seconds
to confirm the settings. The cooker hood and the remote
control are now in line with each other.
pressed.
4
. The lamp on the remote
and
.
and
Publicité
