Télécharger Imprimer la page

Novy Pureline Frame 15001 Mode D'emploi page 39

Publicité

Les langues disponibles

Les langues disponibles

Access to the monoblock filter
The monoblock filter is located at the top of the cooker
hood, below a protection grid. Open the protection grid,
by taking the handle and clicking it off the outlet grid. Then
take out the monoblock filter.
Replace the monoblock filter
Place the monoblock filter back in the opening provided
in the protection grid at the top of the cooker hood. Click
the protection grid back on top of the monoblock filter.

Do not operate the unit without the grease
filters and monoblock filters
Reset the replacement indicator
After replacing the monblock filter(s), carry out
the following action. The motor of the cooker
hood must be running. Simultaneously press
and
for 3 seconds until the red indicator led
3
flashes 3 times for confirmation. If the cooker
hood is not reset, it will automatically reset
after the motor of the cooker hood has been
switched on 10 times.
Installing the monoblock filter
Refer to your recirculation kit manual for removal and
installation of the monoblock filter.

You can obtain a new monoblock filter from
specialist retailers or via the Novy website.
Article number monoblock filter: 7300.055
3.5 Led lighting cooker hood
Replacing the led lighting
First, remove the power supply from the hood and allow
the lighting to cool down sufficiently.
1. Carefully press the spotlight holder; next, remove the
spotlight holder by means of a tilting movement.
2. Removing the LED spotlight:
A. First disconnect the cable leading to the LED spotlight
to be replaced. Disconnecting is done by releasing the
lock by applying a light pressure and pulling it off at
the same time.
B. Then remove the LED spotlight to be replaced by making
a soft rotating movement counterclockwise.
C. Remove the LED spotlight to be replaced from the
bayonet ring.
2
3. Mounting the new LED:
A. Place the new LED light into the locking ring.
B. Make a rotating movement to the right until the LED
light is locked.
C. Connect the power cable.
D. Place the spotlight holder back in the cooker hood and
reconnect the power.
– 39 –

Publicité

loading