Publicité
Les langues disponibles
Les langues disponibles
bottom panel is not suitable for cleaning in the dishwasher.
− Before reinstalling the bottom panel, immediately clean
the accessible parts on the inside of the cooker hood.
− To replace the bottom panel, grasp the bottom panel at
the left and right ends and hold it in place. Make sure
you hold the bottem panel securely at all times.
− Hold the bottom panel in a 90º angle downwards and
slide the bottom panel to the left over the hinges until
you notice a click.
− The bottom panel cannot be closed if the bottom panel
is not fully positioned over the hinges.
− The bottom panel can then be closed.
3.3 Grease filter
If the following instructions are not carried out,
serious soiling can cause a fire hazard.
Indication cleaning grease filter
Indication: 4 flashing indicator lights
After 20 cooking hours 4 flashing indicator LEDs show
that the grease filter must be cleaned.
Reset the cleaning indicator
When you replace the grease filter after clean-
ing, it is sufficient to press the
seconds to again set the indicator.
If you do not do this the indicator light will continue to flash
when switching on the extractor hood.
Accessing the grease filter
Take hold of the right and left side of the bottom panel
(A) and pull down simultaneously. Remove the filter (B) by
tak ing hold of its hook and pulling down.
Cleaning the grease filter
The metal grease filter can be cleaned by hand or in a dish-
washer. We recommend cleaning the grease filter by hand.
Cleaning the filter by hand:
− Immerse the filter in a solution of boiling water to which
− Use a brush for cleaning
− Then rinse the filters with warm water under a tap and
Cleaning the filter in a dishwasher:
When cleaning in a dishwasher the filter may discolour as a
result of the salt content. This does not affect its operation.
− Use a customary dishwasher detergent
− Do not put the saturated grease filters together with
− Select a programme with a low temperature
− After cleaning allow the filter to drain.
Replacing the grease filters
− Before replacing the grease filter, clean the edges of the
− Grasp the filter with 2 hands.
− Make sure that the lock or the lip on the filter is on the
− Insert the back of the filter in the opening, press the filter
key for 5
2
3.4 Monoblock recirculation filter
Replacement indicator monobloc recirculation filter
After a set time a red indicator light on the appliance shows
that the monobloc filter must be replaced.
– 38 –
a degreasing detergent has been added.
allow them to dry.
crockery in the dishwasher
When cleaning in a dishwasher the filter may
discolour as a result of the salt content. This
does not affect its operation.
part in the extractor hood in which the filter is placed.
bottom side.
upwards at the front and make sure it clicks tight.
You can obtain a new grease filter from a dealer
or the Novy website. Article number grease
filter: 6830.020(2x).
Indication: red indicator light stays on
Publicité
