Transmitter Controls - Reely 1:8 EP Rock Crawler 4WD RtR Notice D'emploi



7. Transmitter Controls

1 Telescopic antenna
The antenna can be screwed out and removed for
transport.
2 LC display
3 On/off switch
This slide switch switches the transmitter on and
off. Never switch the transmitter off when the vehicle
is being operated!
4 Charging socket to charge batteries in transmitter
5 Control button for settings menu
6 Power LED
7 "DT3" rocker button for dual rate for steering function
8 "DT4" rocker button for trimming rear axle steering
9 Switching button for steering
10 Lever for forward/reverse propulsion
This lever controls the drive and the braking function
of the vehicle.
11 Dial for steering
12 "DT1" rocker button for trimming front axle steering
13 "DT2" rocker button for trimming/neutral setting of drive
14 The changeable crystal (located on the rear side of the transmitter)
Both the transmitter and the receiver must contain a crystal of the same frequency.
Transmitter crystals are generally marked with "T" or "TX", receiver quartzes with "R" or "RX". Do not mix up the
two crystals!
15 Battery compartment
Insert 8 type AA mignon batteries or 8 rechargeable AA batteries in this compartment in the correct polarity. The
correct polarity is stated in the battery compartment.
1
2
3
4
5
6
7
8
13 12 11
10
9
15
Figure 1
14
31