Publicité
en
english
Mounting steps: Page 7 – 9
It is possible to mount the lights in an upright
or pendant position. The lights must not vi-
brate or jut out above the bonnet, and must
be mounted symmetrically. Determine the
mounting position and mark the fastening
points.
14
Drill using a 3 mm drill bit, and drill out to
11 mm. Seal drilled metal parts with rust pro-
tection. When fitting the lights, Ensure that
the „TOP" marking on the reflector always
points upwards. Align the light in accordance
with the drawing and tighten the screws.
Lay and connect the cables in accordance
with the circuit diagram. (Page 10, 11)
According to circuit diagram a, the auxiliary
lights are switched on together with the ex-
isting spotlights.
According to circuit diagram B, the auxiliary
lights are switched on in addition to the exist-
ing headlights via a separate switch.
it is however essential that country-spe-
cific laws are observed.
Check the lighting system, fasten the connec-
tion cables securely.
have the spotlights adjusted at a special-
max.
ist garage.
4 m
Only correctly adjusted lights provide opti-
mum light.
electrical connection: page 10, 11
Fit the relay with the connection terminals
pointing downwards in a waterproof man-
ner. If required and if legally permitted, fit a
switch in the dashboard.
a useful tip:
Keep the cover lenses clean. Dirt may absorb
up to 80% of the light emitted.
Publicité
