Initial Operation - Cresta DTX390 Mode D'emploi

1.Outdoor temperature 2. Outdoor temperature trend 3. Indoor temperature trend 4.
Indoor temperature 5. Max/Min of indoor 6. Indoor low battery 7. Indoor humidity
trend 8. Indoor humidity 9. Max/Min of outdoor 10. Outdoor humidity trend 11.
Weather 12. Outdoor temperature 13. Outdoor humidity 14. Moonphase 15. History
hour of air pressure 16. Air pressure 17. Air pressure trend
18. Radio controlled Signal symbol 19. Dual alarm 20. DST symbol 21. Time
22. Week 23. Day of the week 24. Month 25. Date 26. Temperature alert 27. Recycling
symbol for channel 28. Channel 29. RF symbol 30. Living space humidity icon
A=MODE B=CH C=ALERT D= SNOOZE•LIGHT
TEMPERATURE AND HUMIDITY I= LED LIGHT J=HANGING HOLE K= CHANNEL

INITIAL OPERATION

• Open the battery compartments located on the rear side of the devices. Place the
batteries in the battery compartments. Observe the shown polarity. The batteries are
backup batteries.
• The altitude icon is flashing, please use the "∧•MEM ", "∨•HISTORY " button to set the
altitude of your position, then press the "SNOOZE•LIGHT" button. The weather station
is set to sea level, so if you live on this level there is no need for adjustment. The
weather symbol is now flashing, please use the "∧•MEM ", "∨•HISTORY" button to choose
the weather.
• The station is now connecting to the outdoor sensor. This process takes about 3
minutes. Then the display shows the outdoor temperature and humidity, in case of
failure of the reception, please press "CH" for more than 3 seconds to receive again.
• The automatic receiving of the DCF radio signal begins after 3 minutes of the outdoor
reception.
• This RCC reception process is going on, the flashing symbol "
display area at the same time.
• Once the radio signal is received successfully, the display shows the symbol "
continuously and stops flashing.
• Please follow the instructions below for the DC 5.0V adapter to the device.
E=∧•MEM F=∨•HISTORY G= 5.0V JACK HOLE
H=
"appears in the time
"