Cresta DTX390 Mode D'emploi page 20

SNOOZE FUNCTION
To activate the snooze function, follow the steps below
• Press the key "SNOOZE•LIGHT" while the alarm sounds, to activate the snooze
function.
• If the snooze function is activated, the alarm symbol is flashing.
• The alarm repeats after 5 minutes.
• The snooze function can be stopped by pressing any key.
• The snooze function will last until you switch it off.
• If you do not switch off the alarm it will last for 2 minutes and stop. In this case the
snooze function will also stop automatically.
12/24 HOURS MODE
The time display can be in 12 (AM/PM）or 24 hours mode.
°C/°F TEMPERATURE DISPLAY
The temperature display can be in °C or °F.
MAX/ MIN FOR THE INDOOR/OUTDOOR TEMPERATURE AND HUMIDITY
Press the "∧•MEM" button for displaying the indoor/outdoor max./min. temperatures and
humidity's.
TEMPERATURE ALERT SET-UP
• Press the "CH" button to select the channel (1, 2, 3) if more than one outdoor sensors
are within reach.
• Press the "ALERT" button to show the alert symbol
• Hold the "ALERT" button, the upper limit temperature is flashing, use the
" "
button to set the maximum alert temperature.
∨•HISTORY
• Press the "ALERT" button, the lower limit temperature is flashing, use the
" "
button to set the minimum alert temperature.
∨•HISTORY
• When the alert is activated, the alert symbol will be shown.
.
TEMPERATURE ALERT ON/OFF
• Press and hold the key "ALERT" to set the temperature alert ON or OFF.
• Alert ON: Temperature alert symbol shown in display
• Alert OFF: Temperature alert symbol goes out.
INFORMATION
• A temperature alert can be set-up for each channel.
• The set-up process cannot be completed if the maximum temperature selected is
lower than the minimum selected temperature.
• The minimum temperature selected must be at least 1°C below the maximum
selected temperature.
" "
and
∧•MEM
" "
and
∧•MEM