Initial Operation - Cresta DTX250 Mode D'emploi

The below picture shows how to connect the stand with the main unit.

INITIAL OPERATION


Open the battery compartment located on the rear side of the devices.
Place the batteries in the battery compartment. Observe the shown polarity.

The station is now connecting to the outdoor sensor. This process takes about 3
minutes. Then the display shows the outdoor temperature and humidity, in case of
failure of reception, pls press "CHANNEL" for more than 3 seconds to receive again.

the automatic receiving of the DCF time signal begins after 3 minutes of outdoor
reception.

This RCC reception process is going on,the flashing symbol "radio tower" appears in
the time display area at the same time.

Once the time signal receiving is successful, the display shows the symbol "radio
tower" continuously and stops flashing.
If, due to bad reception, or no RCC automatic time reception is possible, follow the steps
below to set the time manually.
MANUAL TIME SET-UP
The most important is to quit the reception of the radio controlled signal by
holding together -
"
flashing before set-up

Press and hold the "MODE" key for 3 seconds.

The display for the year is flashing. Use "+ " and "-" to select the year.

Press "MODE" to confirm.

The display for the month is flashing. Use "+ " and "-" to select the month.

Press "MODE" to confirm.
All manuals and user guides at all-guides.com
for 3 seconds in case of the
11
radio tower symbol is