3.1.2 Recommendations for using the battery
In case of anticipating a long period of inactivity for the equipment it is
recommended to store it with the battery fully charged and at temperatures below
25 °C.
It advisable in these cases to carry out each three moths a charge / discharge
cycle and later a partial charge (for example, 50%)
3.2
Installation and start-up.
PROMAX-10
The
A fully charged battery can power the equipment for more than three hours.
When the low battery indicator appears on the display (
recharged.
When a fully discharged battery is installed, it is possible that, due to residual
PROMAX-10
charges, the
automatically disconnect before the low battery indicator appears on the display.
3.2.1 Contrast adjustment
If you are holding down the key CONFIG, you will see the message
"CONTRAST ADJUSTMENT - Move the Encoder" on the screen. In this situation,
turning the rotary knob [9] is possible to adjust the contrast to get the best displaying at
any environmental condition. The new contrast value remains even after you shut down
the instrument.
Page 10
SE
has been designed for use as a portable equipment.
SE
may start up. In this case, the instrument will
USER'S MANUAL.
PROMAX-10
), the battery must be
SE
07/2011