Publicité
Les langues disponibles
Les langues disponibles
3
Slide the joint cover out to protect the
mounting base of the display, then tighten
the fixing screw to secure the cover.
Tighten the screw firmly.
When you tighten a screw, be careful not to
apply too much torque as doing so may damage
the screw (the torque value should be from
1.5 N•m to 2.0 N•m).
4
Attach the rear panel covers along the
guides for protection.
Notes
• Be sure to use the specified screws.
• If the display appears to rattle, tighten the screws
periodically.
Joint cover
Adjusting the display tilt and swivel
angle
After the display is installed, grip the correct parts
of the display and adjust the display angle in the tilt
and swivel directions.
Where to place your hands when gripping the
display:
Front
Notes
• When adjusting the angle of the display, grip the top, left,
or right side of the display with both hands as indicated by
the shaded areas.
• When adjusting the angle of the display, be careful not to
get your fingers caught.
• Do not adjust the display angle while driving.
• Adjust the display angle so that the display does not
obstruct moving parts of the vehicle such as the shift lever
and steering wheel.
Fuse replacement
When replacing the fuse, be sure to
use one matching the amperage
rating stated on the original fuse.
If the fuse blows, check the power
connection and replace the fuse.
If the fuse blows again after
replacement, there may be an
internal malfunction. In such a case, consult your
nearest Sony dealer.
Rear
Fuse (10 A)
21
EN
Publicité
