Publicité
Les langues disponibles
Les langues disponibles
2
Adjust the mounting position of the screw
located where the line () on the swivel
cover is closest to the ground and oriented
horizontally.
The installation angle on the vehicle is
determined based on the vehicle, and the
position of the pre-installed screw is determined
accordingly.
Screw holes to use for each mounting angle:
1
2
3
4
2-A
4-C
3
At the desired position, tighten the 2 screws
through the screw holes (upper, center, or
lower) that match the display angle.
18
EN
A
B
C
3-B
1-A
Note
Install the pre-installed screws in the correct positions.
Installing the screws in incorrect positions will cause the
display to rotate diagonally when you swivel it.
When adjusting to swivel +15°:
Correct position
Adjusting the height of the display
position
1
Remove the 4 pre-installed screws for
height adjustment (on both sides).
2
Slide the connector bracket up or down to
decide the appropriate height position.
Adjustable height: within 60 mm (2
in 7 steps, in 10 mm (
Incorrect position
Pre-installed screws
3
/
in) (),
8
13
/
in) pitch ().
32
Publicité
