Publicité
Les langues disponibles
Les langues disponibles
Special Piping – the two feature system
NO!
Do not plug any outlet on the
ThermoBalance III
Installation:
Caution: Turn the water off at the main before continuing.
Install the hot and cold supply lines on the rough.
The hot supply must be connected to the hot inlet,
and the cold supply must be connected to the cold
inlet. In an older home, confirm that the hot and
cold supplies are not reversed. If the supplies are
not connected to the correct inlets, the valve cannot
function correctly.
Model 06628000 only: When connecting the
hot and cold supplies, hold the stop steady with a
wrench to avoid stop misalignment and breakage
of the factory sealed thread compound.
Install all outlet lines. Do not plug any outlet.
The valve should be level in all planes.
OK!
In this installation, the user wished to
be able to use the showerhead and
the bodysprays simultaneously. Note
how outlet #1 is also connected to the
showerhead.
(For the sake of clarity, the i-box is not
shown in this illustration.)
English
5
Publicité
