Ferrite Core (Europe Only) - Star TSP200-24 Mode D'emploi

3-2. Ferrite Core
NOTE: Take special care when following the procedures listed below.
A ferrite core noise filter for the
peripheral unit cable comes packed
with the printer.
The ferrite core is normally packed
so it is opened, as shown in Fig. 3-1.
Ferrite core (28mm diameter)
One loop
Fig. 3-1
If you find that the ferrite core is not
opened: Use a pointed object to pry
the plastic lock of the ferrite core
apart, as shown in Fig. 3-2. When
opening it, take care not to damage
the ferrite core or the plastic lock.
Fig. 3-2
(Europe only)
– 5 –
• Pass the fastener through the ferrite
core.
Fig. 3-3
• Pass the fastener around the cable
and lock it.
Cut off the excess with a pair of scis-
sors.
Fig. 3-4
Fastener
Pull and cut