Star TSP200-24 Mode D'emploi page 10

Clamp the ferrite core onto the peripheral unit cable, looping the cable as
shown in Fig. 3-1.
• When installing the ferrite core be careful not to damage the cable.
• The ferrite core should be anchored firmly in place with the fastener that
comes with it, as shown in Fig. 3-3 and Fig. 3-4.
• Do not forget to loop the cable.
Connector
Screw M3×4
Peripheral unit drive
circuit connector
Fig. 3-5
– 6 –
Fastener
One loop
Ferrite core
Separate ground wire