Star TSP200-24 Mode D'emploi page 19

Auto cutter unit
Support spacer
Where the catch locks
3 Move the auto cutter unit in the
direction of the arrow until the lock
engages (unnecessary if an auto
cutter unit is not installed).
4 Insert the support spacers for 76mm
paper into the inner left and right
sides of the support guides as shown
in the illustration. Make sure that
the catches on the support spacers
lock onto the holes in the support
guides.
5 Close the auto cutter unit (unneces-
sary if an auto cutter unit is not
installed).
– 15 –