Near-End Sensor - Star TSP200-24 Mode D'emploi

This printer is equipped with a sensor that detects when a roll of paper is near the
end. Read the following if you are going to use this sensor.
Cautions
1) The factory setting is step 1.
2) Always use a paper roll with a core that has an inside diameter of 12 mm and
an outside diameter of 18 mm in order to ensure proper detection of the
remaining paper amount.
3) The near-end sensor is disabled when shipped from the factory. It can be
enabled by rewriting the memory switch. Refer to the "Programmer's
Manual" for details.

4. Near-End Sensor

1 Open the cover.
2 Refer to the table below and set the
detection position for the diameter
of the roll being used.
Roll Diameter
Approx. 22mm
Approx. 26mm
Approx. 30mm
3 Move the sensor and adjust the
guraduation of the sensor to the
adjusted position that corresponds
to the diameter of the roll selected.
Press this hole with a ball point pen or
similar pointed object and slide it into
position. Make sure that the protruding
section (shown by arrow) is securely in
the groove, especially at step 2.
– 8 –
Adjustment
Position
Step 1
Step 2
Step 3