KTM 61912927044 Manuel De Montage page 37

CHANGING THE LOCKING CYLINDER 6
–
Mount the cover with the springs.
The springs are seated correctly on the corresponding
holding lugs.
–
Mount and tighten screws
–
Position rocker arm
–
Mount pin
502017-01
–
Key in vertical position
–
Mount the securing unit.
The spring is seated in the corresponding recess (see
arrow).
502018-01
–
Key position turned clockwise
–
Mount and tighten screws
–
Mount and tighten screws
–
Mount and tighten screws
502011-01
–
Mount lever springs
holding lug.
–
Mount lever
Guideline
Make sure that the lever and springs are seated correctly
and that all holding lugs are hooked in properly (see
arrow).
502019-01
–
Mount the frame with the cover.
–
Mount and tighten screws
–
Mount rubber seal
502009-01
cr
with the washers.
cq
with the spring facing upward.
cp
.
G
.
H
.
cm
.
cn
.
co
.
cl
on both sides of the corresponding
cl
on both sides.
ck
.
bt
.
15