Publicité
Les langues disponibles
Les langues disponibles
5 ASSEMBLY
10
–
Insert the key and check whether the tumblers with the
number 1 are correct.
All tumblers close flush with the locking cylinder.
–
Replace the non-matching tumblers with ones that have
the matching number.
Tip
It is recommended that you note the numbers of
the matching tumblers so that the subsequent
locking cylinders can be equipped immediately.
500517-01
–
Repeat the steps for chambers
six chambers are fitted with the correct tumblers.
–
Insert the key.
All tumblers close flush with the locking cylinder.
500518-01
–
Mount and tighten short locking cylinder adapter
screw (both included).
The holding lug of the locking cylinder adapter (see
arrow) is located on the opposite side of the engaging
plate
501998-01
–
Grease and mount the O-ring
Long-life grease (
–
Position and insert the locking cylinder as shown in the
figure.
The holding lug of the locking cylinder adapter is
facing downward.
Engaging plate
501999-01
–
Key in vertical position
The top case is closed and locked.
–
Move the key 90° to the right
The top case can be opened and closed.
–
Turn the key 45° clockwise
The handle pops up automatically.
The securing lever swings out automatically.
The top case can be opened and closed.
500531-01
The top case is released and can be mounted or remo-
ved.
B
D
,
bq
.
6
(included).
p. 17)
bq
engages.
G
.
H
.
I
.
F
, and
until all
5
with
Publicité
